*
* Startup Code (reset vector)
*
- * do important init only if we don't start from memory!
- * setup Memory and board specific bits prior to relocation.
- * relocate armboot to ram
- * setup stack
+ * Do important init only if we don't start from memory!
+ * Setup memory and board specific bits prior to relocation.
+ * Relocate armboot to ram. Setup stack.
*
*************************************************************************/
skip_errata_798870:
#endif
+#ifdef CONFIG_ARM_ERRATA_801819
+ cmp r2, #0x24 @ Applies to lt including R2p4
+ bgt skip_errata_801819 @ skip if not affected rev
+ cmp r2, #0x20 @ Applies to including and above R2p0
+ blt skip_errata_801819 @ skip if not affected rev
+ mrc p15, 0, r0, c0, c0, 6 @ pick up REVIDR reg
+ and r0, r0, #1 << 3 @ check REVIDR[3]
+ cmp r0, #1 << 3
+ beq skip_errata_801819 @ skip erratum if REVIDR[3] is set
+
+ mrc p15, 0, r0, c1, c0, 1 @ read auxilary control register
+ orr r0, r0, #3 << 27 @ Disables streaming. All write-allocate
+ @ lines allocate in the L1 or L2 cache.
+ orr r0, r0, #3 << 25 @ Disables streaming. All write-allocate
+ @ lines allocate in the L1 cache.
+ push {r1-r5} @ Save the cpu info registers
+ bl v7_arch_cp15_set_acr
+ pop {r1-r5} @ Restore the cpu info - fall through
+skip_errata_801819:
+#endif
+
#ifdef CONFIG_ARM_ERRATA_454179
cmp r2, #0x21 @ Only on < r2p1
bge skip_errata_454179