#include <asm-offsets.h>
#include <config.h>
-#include <version.h>
#include <asm/system.h>
#include <linux/linkage.h>
*
* Startup Code (reset vector)
*
- * do important init only if we don't start from memory!
- * setup Memory and board specific bits prior to relocation.
- * relocate armboot to ram
- * setup stack
+ * Do important init only if we don't start from memory!
+ * Setup memory and board specific bits prior to relocation.
+ * Relocate armboot to ram. Setup stack.
*
*************************************************************************/
* (OMAP4 spl TEXT_BASE is not 32 byte aligned.
* Continue to use ROM code vector only in OMAP4 spl)
*/
-#if !(defined(CONFIG_OMAP44XX) && defined(CONFIG_SPL_BUILD)) && \
- !defined(CONFIG_SPL_FEL)
+#if !(defined(CONFIG_OMAP44XX) && defined(CONFIG_SPL_BUILD))
/* Set V=0 in CP15 SCTLR register - for VBAR to point to vector */
mrc p15, 0, r0, c1, c0, 0 @ Read CP15 SCTLR Register
bic r0, #CR_V @ V = 0
/* the mask ROM code should have PLL and others stable */
#ifndef CONFIG_SKIP_LOWLEVEL_INIT
-#ifndef CONFIG_SPL_FEL
bl cpu_init_cp15
-#endif
bl cpu_init_crit
#endif
mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register
#endif
- mov pc, lr @ back to my caller
+ mov r5, lr @ Store my Caller
+ mrc p15, 0, r1, c0, c0, 0 @ r1 has Read Main ID Register (MIDR)
+ mov r3, r1, lsr #20 @ get variant field
+ and r3, r3, #0xf @ r3 has CPU variant
+ and r4, r1, #0xf @ r4 has CPU revision
+ mov r2, r3, lsl #4 @ shift variant field for combined value
+ orr r2, r4, r2 @ r2 has combined CPU variant + revision
+
+#ifdef CONFIG_ARM_ERRATA_798870
+ cmp r2, #0x30 @ Applies to lower than R3p0
+ bge skip_errata_798870 @ skip if not affected rev
+ cmp r2, #0x20 @ Applies to including and above R2p0
+ blt skip_errata_798870 @ skip if not affected rev
+
+ mrc p15, 1, r0, c15, c0, 0 @ read l2 aux ctrl reg
+ orr r0, r0, #1 << 7 @ Enable hazard-detect timeout
+ push {r1-r5} @ Save the cpu info registers
+ bl v7_arch_cp15_set_l2aux_ctrl
+ isb @ Recommended ISB after l2actlr update
+ pop {r1-r5} @ Restore the cpu info - fall through
+skip_errata_798870:
+#endif
+
+#ifdef CONFIG_ARM_ERRATA_801819
+ cmp r2, #0x24 @ Applies to lt including R2p4
+ bgt skip_errata_801819 @ skip if not affected rev
+ cmp r2, #0x20 @ Applies to including and above R2p0
+ blt skip_errata_801819 @ skip if not affected rev
+ mrc p15, 0, r0, c0, c0, 6 @ pick up REVIDR reg
+ and r0, r0, #1 << 3 @ check REVIDR[3]
+ cmp r0, #1 << 3
+ beq skip_errata_801819 @ skip erratum if REVIDR[3] is set
+
+ mrc p15, 0, r0, c1, c0, 1 @ read auxilary control register
+ orr r0, r0, #3 << 27 @ Disables streaming. All write-allocate
+ @ lines allocate in the L1 or L2 cache.
+ orr r0, r0, #3 << 25 @ Disables streaming. All write-allocate
+ @ lines allocate in the L1 cache.
+ push {r1-r5} @ Save the cpu info registers
+ bl v7_arch_cp15_set_acr
+ pop {r1-r5} @ Restore the cpu info - fall through
+skip_errata_801819:
+#endif
+
+#ifdef CONFIG_ARM_ERRATA_454179
+ cmp r2, #0x21 @ Only on < r2p1
+ bge skip_errata_454179
+
+ mrc p15, 0, r0, c1, c0, 1 @ Read ACR
+ orr r0, r0, #(0x3 << 6) @ Set DBSM(BIT7) and IBE(BIT6) bits
+ push {r1-r5} @ Save the cpu info registers
+ bl v7_arch_cp15_set_acr
+ pop {r1-r5} @ Restore the cpu info - fall through
+
+skip_errata_454179:
+#endif
+
+#ifdef CONFIG_ARM_ERRATA_430973
+ cmp r2, #0x21 @ Only on < r2p1
+ bge skip_errata_430973
+
+ mrc p15, 0, r0, c1, c0, 1 @ Read ACR
+ orr r0, r0, #(0x1 << 6) @ Set IBE bit
+ push {r1-r5} @ Save the cpu info registers
+ bl v7_arch_cp15_set_acr
+ pop {r1-r5} @ Restore the cpu info - fall through
+
+skip_errata_430973:
+#endif
+
+#ifdef CONFIG_ARM_ERRATA_621766
+ cmp r2, #0x21 @ Only on < r2p1
+ bge skip_errata_621766
+
+ mrc p15, 0, r0, c1, c0, 1 @ Read ACR
+ orr r0, r0, #(0x1 << 5) @ Set L1NEON bit
+ push {r1-r5} @ Save the cpu info registers
+ bl v7_arch_cp15_set_acr
+ pop {r1-r5} @ Restore the cpu info - fall through
+
+skip_errata_621766:
+#endif
+
+ mov pc, r5 @ back to my caller
ENDPROC(cpu_init_cp15)
#ifndef CONFIG_SKIP_LOWLEVEL_INIT