- CONFIG_SYS_I2C_IHS_CH3 activate hardware channel 3
- CONFIG_SYS_I2C_IHS_SPEED_3 speed channel 3
- CONFIG_SYS_I2C_IHS_SLAVE_3 slave addr channel 3
+ - activate dual channel with CONFIG_SYS_I2C_IHS_DUAL
+ - CONFIG_SYS_I2C_IHS_SPEED_0_1 speed channel 0_1
+ - CONFIG_SYS_I2C_IHS_SLAVE_0_1 slave addr channel 0_1
+ - CONFIG_SYS_I2C_IHS_SPEED_1_1 speed channel 1_1
+ - CONFIG_SYS_I2C_IHS_SLAVE_1_1 slave addr channel 1_1
+ - CONFIG_SYS_I2C_IHS_SPEED_2_1 speed channel 2_1
+ - CONFIG_SYS_I2C_IHS_SLAVE_2_1 slave addr channel 2_1
+ - CONFIG_SYS_I2C_IHS_SPEED_3_1 speed channel 3_1
+ - CONFIG_SYS_I2C_IHS_SLAVE_3_1 slave addr channel 3_1
additional defines:
CONFIG_SYS_SPL_MALLOC_START
Starting address of the malloc pool used in SPL.
+ When this option is set the full malloc is used in SPL and
+ it is set up by spl_init() and before that, the simple malloc()
+ can be used if CONFIG_SYS_MALLOC_F is defined.
CONFIG_SYS_SPL_MALLOC_SIZE
The size of the malloc pool used in SPL.
unset, then it will be made silent if the U-Boot console
is silent.
- tftpsrcport - If this is set, the value is used for TFTP's
+ tftpsrcp - If this is set, the value is used for TFTP's
UDP source port.
- tftpdstport - If this is set, the value is used for TFTP's UDP
+ tftpdstp - If this is set, the value is used for TFTP's UDP
destination port instead of the Well Know Port 69.
tftpblocksize - Block size to use for TFTP transfers; if not set,
faster in networks with high packet loss rates or
with unreliable TFTP servers.
+ tftptimeoutcountmax - maximum count of TFTP timeouts (no
+ unit, minimum value = 0). Defines how many timeouts
+ can happen during a single file transfer before that
+ transfer is aborted. The default is 10, and 0 means
+ 'no timeouts allowed'. Increasing this value may help
+ downloads succeed with high packet loss rates, or with
+ unreliable TFTP servers or client hardware.
+
vlan - When set to a value < 4095 the traffic over
Ethernet is encapsulated/received over 802.1q
VLAN tagged frames.