+config BITREVERSE
+ bool "Bit reverse library from Linux"
+
+config TRACE
+ bool "Support for tracing of function calls and timing"
+ imply CMD_TRACE
+ help
+ Enables function tracing within U-Boot. This allows recording of call
+ traces including timing information. The command can write data to
+ memory for exporting for analysis (e.g. using bootchart).
+ See doc/README.trace for full details.
+
+config TRACE_BUFFER_SIZE
+ hex "Size of trace buffer in U-Boot"
+ depends on TRACE
+ default 0x01000000
+ help
+ Sets the size of the trace buffer in U-Boot. This is allocated from
+ memory during relocation. If this buffer is too small, the trace
+ history will be truncated, with later records omitted.
+
+ If early trace is enabled (i.e. before relocation), this buffer must
+ be large enough to include all the data from the early trace buffer as
+ well, since this is copied over to the main buffer during relocation.
+
+ A trace record is emitted for each function call and each record is
+ 12 bytes (see struct trace_call). A suggested minimum size is 1MB. If
+ the size is too small then 'trace stats' will show a message saying
+ how many records were dropped due to buffer overflow.
+
+config TRACE_CALL_DEPTH_LIMIT
+ int "Trace call depth limit"
+ depends on TRACE
+ default 15
+ help
+ Sets the maximum call depth up to which function calls are recorded.
+
+config TRACE_EARLY
+ bool "Enable tracing before relocation"
+ depends on TRACE
+ help
+ Sometimes it is helpful to trace execution of U-Boot before
+ relocation. This is possible by using a arch-specific, fixed buffer
+ position in memory. Enable this option to start tracing as early as
+ possible after U-Boot starts.
+
+config TRACE_EARLY_SIZE
+ hex "Size of early trace buffer in U-Boot"
+ depends on TRACE_EARLY
+ default 0x00100000
+ help
+ Sets the size of the early trace buffer in bytes. This is used to hold
+ tracing information before relocation.
+
+config TRACE_EARLY_CALL_DEPTH_LIMIT
+ int "Early trace call depth limit"
+ depends on TRACE_EARLY
+ default 200
+ help
+ Sets the maximum call depth up to which function calls are recorded
+ during early tracing.
+
+config TRACE_EARLY_ADDR
+ hex "Address of early trace buffer in U-Boot"
+ depends on TRACE_EARLY
+ default 0x00100000
+ help
+ Sets the address of the early trace buffer in U-Boot. This memory
+ must be accessible before relocation.
+
+ A trace record is emitted for each function call and each record is
+ 12 bytes (see struct trace_call). A suggested minimum size is 1MB. If
+ the size is too small then the message which says the amount of early
+ data being coped will the the same as the
+