+config STM32_SERIAL
+ bool "STMicroelectronics STM32 SoCs on-chip UART"
+ depends on DM_SERIAL && (STM32F4 || STM32F7 || STM32H7 || ARCH_STM32MP)
+ help
+ If you have a machine based on a STM32 F4, F7, H7 or MP1 SOC
+ you can enable its onboard serial ports, say Y to this option.
+ If unsure, say N.
+
+config ZYNQ_SERIAL
+ bool "Cadence (Xilinx Zynq) UART support"
+ depends on DM_SERIAL && (MICROBLAZE || ARCH_ZYNQ || ARCH_ZYNQMP || ARCH_ZYNQMP_R5)
+ help
+ This driver supports the Cadence UART. It is found e.g. in Xilinx
+ Zynq/ZynqMP.
+
+config MPC8XX_CONS
+ bool "Console driver for MPC8XX"
+ depends on MPC8xx
+ default y
+
+choice
+ prompt "Console port"
+ default 8xx_CONS_SMC1
+ depends on MPC8XX_CONS
+ help
+ Depending on board, select one serial port
+ (CONFIG_8xx_CONS_SMC1 or CONFIG_8xx_CONS_SMC2)
+
+config 8xx_CONS_SMC1
+ bool "SMC1"
+
+config 8xx_CONS_SMC2
+ bool "SMC2"
+
+endchoice
+
+config SYS_SMC_RXBUFLEN
+ int "Console Rx buffer length"
+ depends on MPC8XX_CONS
+ default 1
+ help
+ With CONFIG_SYS_SMC_RXBUFLEN it is possible to define
+ the maximum receive buffer length for the SMC.
+ This option is actual only for 8xx possible.
+ If using CONFIG_SYS_SMC_RXBUFLEN also CONFIG_SYS_MAXIDLE
+ must be defined, to setup the maximum idle timeout for
+ the SMC.
+
+config SYS_MAXIDLE
+ int "maximum idle timeout"
+ depends on MPC8XX_CONS
+ default 0
+
+config SYS_BRGCLK_PRESCALE
+ int "BRG Clock Prescale"
+ depends on MPC8XX_CONS
+ default 1
+
+config SYS_SDSR
+ hex "SDSR Value"
+ depends on MPC8XX_CONS
+ default 0x83
+
+config SYS_SDMR
+ hex "SDMR Value"
+ depends on MPC8XX_CONS
+ default 0
+