-#include <i2c.h>
-#include <axp209.h>
-
-enum axp209_reg {
- AXP209_POWER_STATUS = 0x00,
- AXP209_CHIP_VERSION = 0x03,
- AXP209_DCDC2_VOLTAGE = 0x23,
- AXP209_DCDC3_VOLTAGE = 0x27,
- AXP209_LDO24_VOLTAGE = 0x28,
- AXP209_LDO3_VOLTAGE = 0x29,
- AXP209_IRQ_STATUS5 = 0x4c,
- AXP209_SHUTDOWN = 0x32,
- AXP209_GPIO0_CTRL = 0x90,
- AXP209_GPIO1_CTRL = 0x92,
- AXP209_GPIO2_CTRL = 0x93,
- AXP209_GPIO_STATE = 0x94,
- AXP209_GPIO3_CTRL = 0x95,
-};
-
-#define AXP209_POWER_STATUS_ON_BY_DC (1 << 0)
-
-#define AXP209_IRQ5_PEK_UP (1 << 6)
-#define AXP209_IRQ5_PEK_DOWN (1 << 5)
-
-#define AXP209_POWEROFF (1 << 7)
-
-#define AXP209_GPIO_OUTPUT_LOW 0x00 /* Drive pin low */
-#define AXP209_GPIO_OUTPUT_HIGH 0x01 /* Drive pin high */
-#define AXP209_GPIO_INPUT 0x02 /* Float pin */
-
-/* GPIO3 is different from the others */
-#define AXP209_GPIO3_OUTPUT_LOW 0x00 /* Drive pin low, Output mode */
-#define AXP209_GPIO3_OUTPUT_HIGH 0x02 /* Float pin, Output mode */
-#define AXP209_GPIO3_INPUT 0x06 /* Float pin, Input mode */
-
-static int axp209_write(enum axp209_reg reg, u8 val)
-{
- return i2c_write(0x34, reg, 1, &val, 1);
-}
-
-static int axp209_read(enum axp209_reg reg, u8 *val)
-{
- return i2c_read(0x34, reg, 1, val, 1);
-}
+#include <command.h>
+#include <asm/arch/pmic_bus.h>
+#include <axp_pmic.h>
+
+#ifdef CONFIG_AXP_ALDO3_VOLT_SLOPE_08
+# define AXP209_VRC_SLOPE AXP209_VRC_LDO3_800uV_uS
+#endif
+#ifdef CONFIG_AXP_ALDO3_VOLT_SLOPE_16
+# define AXP209_VRC_SLOPE AXP209_VRC_LDO3_1600uV_uS
+#endif
+#if defined CONFIG_AXP_ALDO3_VOLT_SLOPE_NONE || !defined AXP209_VRC_SLOPE
+# define AXP209_VRC_SLOPE 0x00
+#endif