+
+#ifdef CONFIG_PS2MULT
+
+#ifdef CONFIG_HMI10
+#define BASE_BAUD ( 1843200 / 16 )
+struct serial_state rs_table[] = {
+ { BASE_BAUD, 4, (void*)0xec140000 },
+ { BASE_BAUD, 2, (void*)0xec150000 },
+ { BASE_BAUD, 6, (void*)0xec160000 },
+ { BASE_BAUD, 10, (void*)0xec170000 },
+};
+
+#ifdef CONFIG_BOARD_EARLY_INIT_R
+int board_early_init_r (void)
+{
+ ps2mult_early_init();
+ return (0);
+}
+#endif
+#endif /* CONFIG_HMI10 */
+
+#endif /* CONFIG_PS2MULT */
+
+/* ---------------------------------------------------------------------------- */
+/* HMI10 specific stuff */
+/* ---------------------------------------------------------------------------- */
+#ifdef CONFIG_HMI10
+
+int misc_init_r (void)
+{
+# ifdef CONFIG_IDE_LED
+ volatile immap_t *immap = (immap_t *) CFG_IMMR;
+
+ /* Configure PA15 as output port */
+ immap->im_ioport.iop_padir |= 0x0001;
+ immap->im_ioport.iop_paodr |= 0x0001;
+ immap->im_ioport.iop_papar &= ~0x0001;
+ immap->im_ioport.iop_padat &= ~0x0001; /* turn it off */
+# endif
+ return (0);
+}
+
+# ifdef CONFIG_IDE_LED
+void ide_led (uchar led, uchar status)
+{
+ volatile immap_t *immap = (immap_t *) CFG_IMMR;
+
+ /* We have one led for both pcmcia slots */
+ if (status) { /* led on */
+ immap->im_ioport.iop_padat |= 0x0001;
+ } else {
+ immap->im_ioport.iop_padat &= ~0x0001;
+ }
+}
+# endif
+#endif /* CONFIG_HMI10 */
+
+/* ---------------------------------------------------------------------------- */
+/* NSCU specific stuff */
+/* ---------------------------------------------------------------------------- */
+#ifdef CONFIG_NSCU
+
+int misc_init_r (void)
+{
+ volatile immap_t *immr = (immap_t *) CFG_IMMR;
+
+ /* wake up ethernet module */
+ immr->im_ioport.iop_pcpar &= ~0x0004; /* GPIO pin */
+ immr->im_ioport.iop_pcdir |= 0x0004; /* output */
+ immr->im_ioport.iop_pcso &= ~0x0004; /* for clarity */
+ immr->im_ioport.iop_pcdat |= 0x0004; /* enable */
+
+ return (0);
+}
+#endif /* CONFIG_NSCU */
+
+/* ------------------------------------------------------------------------- */