+#if defined(CONFIG_SPL_OS_BOOT)
+int spl_start_uboot(void)
+{
+ /* break into full u-boot on 'c' */
+ if (serial_tstc() && serial_getc() == 'c')
+ return 1;
+
+ return 0;
+}
+#endif /* CONFIG_SPL_OS_BOOT */
+
+#if defined(CONFIG_SPL_BUILD)
+/*
+ * Routine: get_board_mem_timings
+ * Description: If we use SPL then there is no x-loader nor config header
+ * so we have to setup the DDR timings ourself on the first bank. This
+ * provides the timing values back to the function that configures
+ * the memory.
+ */
+void get_board_mem_timings(struct board_sdrc_timings *timings)
+{
+ int pop_mfr, pop_id;
+
+ /*
+ * We need to identify what PoP memory is on the board so that
+ * we know what timings to use. To map the ID values please see
+ * nand_ids.c
+ */
+ identify_nand_chip(&pop_mfr, &pop_id);
+
+ if (pop_mfr == NAND_MFR_HYNIX && pop_id == 0xbc) {
+ /* 256MB DDR */
+ timings->mcfg = HYNIX_V_MCFG_200(256 << 20);
+ timings->ctrla = HYNIX_V_ACTIMA_200;
+ timings->ctrlb = HYNIX_V_ACTIMB_200;
+ } else {
+ /* 128MB DDR */
+ timings->mcfg = MICRON_V_MCFG_165(128 << 20);
+ timings->ctrla = MICRON_V_ACTIMA_165;
+ timings->ctrlb = MICRON_V_ACTIMB_165;
+ }
+ timings->rfr_ctrl = SDP_3430_SDRC_RFR_CTRL_165MHz;
+ timings->mr = MICRON_V_MR_165;
+}
+#endif /* CONFIG_SPL_BUILD */
+
+#if defined(CONFIG_USB_MUSB_OMAP2PLUS)
+static struct musb_hdrc_config musb_config = {
+ .multipoint = 1,
+ .dyn_fifo = 1,
+ .num_eps = 16,
+ .ram_bits = 12,
+};
+
+static struct omap_musb_board_data musb_board_data = {
+ .interface_type = MUSB_INTERFACE_ULPI,
+};
+
+static struct musb_hdrc_platform_data musb_plat = {
+#if defined(CONFIG_USB_MUSB_HOST)
+ .mode = MUSB_HOST,
+#elif defined(CONFIG_USB_MUSB_GADGET)
+ .mode = MUSB_PERIPHERAL,
+#else
+#error "Please define either CONFIG_USB_MUSB_HOST or CONFIG_USB_MUSB_GADGET"
+#endif /* CONFIG_USB_MUSB_{GADGET,HOST} */
+ .config = &musb_config,
+ .power = 100,
+ .platform_ops = &omap2430_ops,
+ .board_data = &musb_board_data,
+};
+#endif /* CONFIG_USB_MUSB_OMAP2PLUS */
+