-int pci_pre_init(struct pci_controller * hose )
-{
- unsigned long strap;
-
- /*-------------------------------------------------------------------+
- * The katmai board is always configured as the host & requires the
- * PCI arbiter to be enabled.
- *-------------------------------------------------------------------*/
- mfsdr(SDR0_SDSTP1, strap);
- if( (strap & SDR0_SDSTP1_PAE_MASK) == 0 ) {
- printf("PCI: SDR0_STRP1[%08lX] - PCI Arbiter disabled.\n",strap);
- return 0;
- }
-
- return 1;
-}
-#endif /* defined(CONFIG_PCI) */
-
-/*************************************************************************
- * pci_target_init
- *
- * The bootstrap configuration provides default settings for the pci
- * inbound map (PIM). But the bootstrap config choices are limited and
- * may not be sufficient for a given board.
- *
- ************************************************************************/
-#if defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT)
-void pci_target_init(struct pci_controller * hose )
-{
- /*-------------------------------------------------------------------+
- * Disable everything
- *-------------------------------------------------------------------*/
- out32r( PCIL0_PIM0SA, 0 ); /* disable */
- out32r( PCIL0_PIM1SA, 0 ); /* disable */
- out32r( PCIL0_PIM2SA, 0 ); /* disable */
- out32r( PCIL0_EROMBA, 0 ); /* disable expansion rom */
-
- /*-------------------------------------------------------------------+
- * Map all of SDRAM to PCI address 0x0000_0000. Note that the 440
- * strapping options to not support sizes such as 128/256 MB.
- *-------------------------------------------------------------------*/
- out32r( PCIL0_PIM0LAL, CONFIG_SYS_SDRAM_BASE );
- out32r( PCIL0_PIM0LAH, 0 );
- out32r( PCIL0_PIM0SA, ~(gd->ram_size - 1) | 1 );
- out32r( PCIL0_BAR0, 0 );
-
- /*-------------------------------------------------------------------+
- * Program the board's subsystem id/vendor id
- *-------------------------------------------------------------------*/
- out16r( PCIL0_SBSYSVID, CONFIG_SYS_PCI_SUBSYS_VENDORID );
- out16r( PCIL0_SBSYSID, CONFIG_SYS_PCI_SUBSYS_DEVICEID );
-
- out16r( PCIL0_CMD, in16r(PCIL0_CMD) | PCI_COMMAND_MEMORY );
-}
-#endif /* defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT) */
-
-#if defined(CONFIG_PCI)
-/*************************************************************************
- * is_pci_host
- *
- * This routine is called to determine if a pci scan should be
- * performed. With various hardware environments (especially cPCI and
- * PPMC) it's insufficient to depend on the state of the arbiter enable
- * bit in the strap register, or generic host/adapter assumptions.
- *
- * Rather than hard-code a bad assumption in the general 440 code, the
- * 440 pci code requires the board to decide at runtime.
- *
- * Return 0 for adapter mode, non-zero for host (monarch) mode.
- *
- *
- ************************************************************************/
-int is_pci_host(struct pci_controller *hose)
-{
- /* The katmai board is always configured as host. */
- return 1;
-}
-