imx6: move generic imx6 options to mx6_common.h

[oweals/u-boot.git] / README

diff --git a/README b/README
index a70af9864676652bd127fc1cdb1dfc7739472e96..1ea397a35cadd7efcb7008e815ea13074320794c 100644 (file)
--- a/README
+++ b/README
@@ -1873,12 +1873,6 @@ CBFS (Coreboot Filesystem) support
                boot.  See the documentation file README.video for a
                description of this variable.
 
                boot.  See the documentation file README.video for a
                description of this variable.
 

-               CONFIG_VIDEO_VGA
-
-               Enable the VGA video / BIOS for x86. The alternative if you
-               are using coreboot is to use the coreboot frame buffer
-               driver.
-

 
 - Keyboard Support:
                CONFIG_KEYBOARD
 
 - Keyboard Support:
                CONFIG_KEYBOARD


@@ -3096,17 +3090,6 @@ CBFS (Coreboot Filesystem) support
                memories can be connected with a given cs line.
                Currently Xilinx Zynq qspi supports these type of connections.
 
                memories can be connected with a given cs line.
                Currently Xilinx Zynq qspi supports these type of connections.
 

-               CONFIG_SYS_SPI_ST_ENABLE_WP_PIN
-               enable the W#/Vpp signal to disable writing to the status
-               register on ST MICRON flashes like the N25Q128.
-               The status register write enable/disable bit, combined with
-               the W#/VPP signal provides hardware data protection for the
-               device as follows: When the enable/disable bit is set to 1,
-               and the W#/VPP signal is driven LOW, the status register
-               nonvolatile bits become read-only and the WRITE STATUS REGISTER
-               operation will not execute. The only way to exit this
-               hardware-protected mode is to drive W#/VPP HIGH.
-

 - SystemACE Support:
                CONFIG_SYSTEMACE
 
 - SystemACE Support:
                CONFIG_SYSTEMACE
 


@@ -5490,7 +5473,7 @@ loaded to, and "Flash Location" gives the image's address in NOR
 flash or offset in NAND flash.
 
 *Note* - these variables don't have to be defined for all boards, some
 flash or offset in NAND flash.
 
 *Note* - these variables don't have to be defined for all boards, some

-boards currenlty use other variables for these purposes, and some
+boards currently use other variables for these purposes, and some

 boards use these variables for other purposes.
 
 Image              File Name        RAM Address       Flash Location
 boards use these variables for other purposes.
 
 Image              File Name        RAM Address       Flash Location