/dts-v1/; #include "mt7621.dtsi" #include #include / { compatible = "hiwifi,hc5962", "mediatek,mt7621-soc"; model = "HiWiFi HC5962"; aliases { led-boot = &led_system; led-failsafe = &led_system; led-running = &led_status; led-upgrade = &led_status; }; chosen { bootargs = "console=ttyS0,115200"; }; leds { compatible = "gpio-leds"; led_status: status { label = "hc5962:white:status"; gpios = <&gpio 6 GPIO_ACTIVE_LOW>; }; led_system: system { label = "hc5962:red:system"; gpios = <&gpio 7 GPIO_ACTIVE_LOW>; panic-indicator; }; }; keys { compatible = "gpio-keys"; reset { label = "reset"; gpios = <&gpio 18 GPIO_ACTIVE_HIGH>; linux,code = ; }; }; }; &nand { status = "okay"; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "u-boot"; reg = <0x0 0x80000>; read-only; }; partition@80000 { label = "debug"; reg = <0x80000 0x80000>; read-only; }; factory: partition@100000 { label = "factory"; reg = <0x100000 0x40000>; read-only; }; partition@140000 { label = "kernel"; reg = <0x140000 0x200000>; }; partition@340000 { label = "ubi"; reg = <0x340000 0x1E00000>; }; partition@2140000 { label = "hw_panic"; reg = <0x2140000 0x80000>; read-only; }; partition@21c0000 { label = "bdinfo"; reg = <0x21c0000 0x80000>; read-only; }; partition@2240000 { label = "backup"; reg = <0x2240000 0x80000>; read-only; }; partition@22c0000 { label = "overly"; reg = <0x22c0000 0x1000000>; }; partition@32c0000 { label = "firmware_backup"; reg = <0x32c0000 0x2000000>; }; partition@52c0000 { label = "oem"; reg = <0x52c0000 0x200000>; }; partition@54c0000 { label = "opt"; reg = <0x54c0000 0x2ac0000>; }; }; }; &pcie { status = "okay"; }; &pcie0 { mt76@0,0 { reg = <0x0000 0 0 0 0>; mediatek,mtd-eeprom = <&factory 0x0000>; ieee80211-freq-limit = <2400000 2500000>; }; }; &pcie1 { mt76@0,0 { reg = <0x0000 0 0 0 0>; mediatek,mtd-eeprom = <&factory 0x8000>; ieee80211-freq-limit = <5000000 6000000>; }; }; &switch0 { ports { port@1 { status = "okay"; label = "lan1"; }; port@2 { status = "okay"; label = "lan2"; }; port@3 { status = "okay"; label = "lan3"; }; port@4 { status = "okay"; label = "wan"; }; }; }; &state_default { gpio { groups = "uart3", "jtag"; function = "gpio"; }; };