5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/input/input.h>
9 model = "Sitecom WLR-6000";
12 compatible = "gpio-keys-polled";
19 gpios = <&gpio1 2 GPIO_ACTIVE_LOW>;
20 linux,code = <KEY_RESTART>;
25 compatible = "gpio-leds";
28 label = "wlr-6000:red:power";
29 gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
33 label = "wlr-6000:white:ops";
34 gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
39 compatible = "gpio-export";
43 gpio-export,name = "usb";
44 gpio-export,output = <1>;
45 gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
55 state_default: pinctrl0 {
57 ralink,group = "i2c", "jtag", "uartf";
58 ralink,function = "gpio";
65 mtd-mac-address = <&factory 0x8004>;
66 mtd-mac-address-increment = <1>;
76 phy0: ethernet-phy@0 {
80 qca,ar8327-initvals = <
81 0x04 0x07600000 /* PORT0 PAD MODE CTRL */
82 0x0c 0x07600000 /* PORT6 PAD MODE CTRL */
83 0x10 0x40000000 /* Power-on Strapping: 176-pin interface configuration */
84 0x50 0xc437c437 /* LED Control Register 0 */
85 0x54 0xc337c337 /* LED Control Register 1 */
86 0x58 0x00000000 /* LED Control Register 2 */
87 0x5c 0x03ffff00 /* LED Control Register 3 */
88 0x7c 0x0000007e /* PORT0_STATUS */
89 0x94 0x0000007e /* PORT6 STATUS */
101 compatible = "jedec,spi-nor";
103 spi-max-frequency = <8600000>;
113 label = "u-boot-env";
114 reg = <0x30000 0x10000>;
118 factory: partition@40000 {
120 reg = <0x40000 0x10000>;
126 reg = <0x50000 0x713000>;
130 label = "manufacture";
131 reg = <0x763000 0x7D000>;
137 reg = <0x7E0000 0x10000>;
143 reg = <0x7F0000 0x10000>;
151 pinctrl-names = "default";
152 pinctrl-0 = <&pci_pins>;
156 ralink,group = "pci";
157 ralink,function = "pci-fnc";
166 compatible = "pci1814,3091";
167 reg = <0x10000 0 0 0 0>;
168 ralink,mtd-eeprom = <&factory 0x8000>;
177 ralink,mtd-eeprom = <&factory 0x0>;