5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/input/input.h>
9 compatible = "sitecom,wlr-6000", "ralink,rt3883-soc";
10 model = "Sitecom WLR-6000";
13 compatible = "gpio-keys-polled";
20 gpios = <&gpio1 2 GPIO_ACTIVE_LOW>;
21 linux,code = <KEY_RESTART>;
26 compatible = "gpio-leds";
29 label = "wlr-6000:red:power";
30 gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
34 label = "wlr-6000:white:ops";
35 gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
40 compatible = "gpio-export";
44 gpio-export,name = "usb";
45 gpio-export,output = <1>;
46 gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
56 state_default: pinctrl0 {
58 ralink,group = "i2c", "jtag", "uartf";
59 ralink,function = "gpio";
66 mtd-mac-address = <&factory 0x8004>;
67 mtd-mac-address-increment = <1>;
77 phy0: ethernet-phy@0 {
81 qca,ar8327-initvals = <
82 0x04 0x07600000 /* PORT0 PAD MODE CTRL */
83 0x0c 0x07600000 /* PORT6 PAD MODE CTRL */
84 0x10 0x40000000 /* Power-on Strapping: 176-pin interface configuration */
85 0x50 0xc437c437 /* LED Control Register 0 */
86 0x54 0xc337c337 /* LED Control Register 1 */
87 0x58 0x00000000 /* LED Control Register 2 */
88 0x5c 0x03ffff00 /* LED Control Register 3 */
89 0x7c 0x0000007e /* PORT0_STATUS */
90 0x94 0x0000007e /* PORT6 STATUS */
100 #address-cells = <1>;
102 compatible = "jedec,spi-nor";
104 spi-max-frequency = <8600000>;
114 label = "u-boot-env";
115 reg = <0x30000 0x10000>;
119 factory: partition@40000 {
121 reg = <0x40000 0x10000>;
127 reg = <0x50000 0x713000>;
131 label = "manufacture";
132 reg = <0x763000 0x7D000>;
138 reg = <0x7E0000 0x10000>;
144 reg = <0x7F0000 0x10000>;
152 pinctrl-names = "default";
153 pinctrl-0 = <&pci_pins>;
157 ralink,group = "pci";
158 ralink,function = "pci-fnc";
167 compatible = "pci1814,3091";
168 reg = <0x10000 0 0 0 0>;
169 ralink,mtd-eeprom = <&factory 0x8000>;
178 ralink,mtd-eeprom = <&factory 0x0>;