target/linux/ramips/dts/WL-351.dts

   1 /dts-v1/;
   2
   3 #include "rt3050.dtsi"
   4
   5 #include <dt-bindings/gpio/gpio.h>
   6 #include <dt-bindings/input/input.h>
   7
   8 / {
   9         compatible = "sitecom,wl-351", "ralink,rt3052-soc";
  10         model = "Sitecom WL-351 v1 002";
  11
  12         cfi@1f000000 {
  13                 compatible = "cfi-flash";
  14                 reg = <0x1f000000 0x800000>;
  15                 bank-width = <2>;
  16                 device-width = <2>;
  17                 #address-cells = <1>;
  18                 #size-cells = <1>;
  19
  20                 partition@0 {
  21                         label = "u-boot";
  22                         reg = <0x0 0x30000>;
  23                         read-only;
  24                 };
  25
  26                 partition@30000 {
  27                         label = "u-boot-env";
  28                         reg = <0x30000 0x10000>;
  29                         read-only;
  30                 };
  31
  32                 factory: partition@40000 {
  33                         label = "factory";
  34                         reg = <0x40000 0x10000>;
  35                         read-only;
  36                 };
  37
  38                 partition@50000 {
  39                         label = "firmware";
  40                         reg = <0x50000 0x3b0000>;
  41                 };
  42         };
  43
  44         gpio-leds {
  45                 compatible = "gpio-leds";
  46
  47                 power {
  48                         label = "wl-351:amber:power";
  49                         gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
  50                 };
  51
  52                 unpopulated {
  53                         label = "wl-351:amber:unpopulated";
  54                         gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
  55                 };
  56
  57                 unpopulated2 {
  58                         label = "wl-351:blue:unpopulated";
  59                         gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
  60                 };
  61         };
  62
  63         gpio-keys-polled {
  64                 compatible = "gpio-keys-polled";
  65                 #address-cells = <1>;
  66                 #size-cells = <0>;
  67                 poll-interval = <20>;
  68
  69                 reset {
  70                         label = "reset";
  71                         gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
  72                         linux,code = <KEY_RESTART>;
  73                 };
  74
  75                 wps {
  76                         label = "wps";
  77                         gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
  78                         linux,code = <KEY_WPS_BUTTON>;
  79                 };
  80         };
  81
  82         rtl8366rb {
  83                 compatible = "realtek,rtl8366rb";
  84                 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
  85                 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
  86         };
  87 };
  88
  89 &pinctrl {
  90         state_default: pinctrl0 {
  91                 gpio {
  92                         ralink,group = "spi", "i2c", "jtag", "mdio", "uartf";
  93                         ralink,function = "gpio";
  94                 };
  95         };
  96 };
  97
  98 &ethernet {
  99         mtd-mac-address = <&factory 0x4>;
 100         pinctrl-names = "default";
 101         pinctrl-0 = <&rgmii_pins>;
 102 };
 103
 104 &esw {
 105         ralink,rgmii = <1>;
 106         mediatek,portmap = <0x3f>;
 107         ralink,fct2 = <0x0002500c>;
 108         /*
 109          * ext phy base addr 31, rx/tx clock skew 0,
 110          * turbo mii off, rgmi 3.3v off, port 5 polling off
 111          * port5: enabled, gige, full-duplex, rx/tx-flow-control
 112          * port6: enabled, gige, full-duplex, rx/tx-flow-control
 113         */
 114         ralink,fpa2 = <0x1f003fff>;
 115 };
 116
 117 &wmac {
 118         ralink,mtd-eeprom = <&factory 0>;
 119 };
 120
 121 &otg {
 122         status = "okay";
 123 };