5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/input/input.h>
9 compatible = "dlink,dap-1522-a1", "ralink,rt2880-soc";
10 model = "D-Link DAP-1522 A1";
13 led-boot = &led_status;
14 led-failsafe = &led_status;
15 led-running = &led_status;
16 led-upgrade = &led_status;
20 compatible = "cfi-flash";
21 reg = <0xbc400000 0x800000>;
26 compatible = "fixed-partitions";
36 factory: partition@30000 {
38 reg = <0x30000 0x10000>;
45 reg = <0x40000 0x3a0000>;
51 compatible = "realtek,rtl8366s";
52 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
53 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
57 compatible = "gpio-keys-polled";
58 poll-interval = <100>;
62 gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
63 linux,code = <KEY_RESTART>;
68 gpios = <&gpio2 16 GPIO_ACTIVE_LOW>;
69 linux,code = <KEY_WPS_BUTTON>;
74 gpios = <&gpio2 13 GPIO_ACTIVE_LOW>;
76 linux,input-type = <EV_SW>;
81 gpios = <&gpio2 14 GPIO_ACTIVE_LOW>;
83 linux,input-type = <EV_SW>;
88 compatible = "gpio-leds";
91 label = "dap-1522-a1:blue:wps";
92 gpios = <&gpio2 17 GPIO_ACTIVE_LOW>;
96 label = "dap-1522-a1:blue:ap";
97 gpios = <&gpio2 18 GPIO_ACTIVE_LOW>;
101 label = "dap-1522-a1:red:sta";
102 gpios = <&gpio2 19 GPIO_ACTIVE_LOW>;
106 label = "dap-1522-a1:blue:status";
107 gpios = <&gpio2 20 GPIO_ACTIVE_LOW>;
121 state_default: pinctrl0 {
123 ralink,group = "i2c", "uartlite", "pci";
124 ralink,function = "gpio";
131 mtd-mac-address = <&factory 0x2004>;
134 mediatek,fixed-link = <1000 1 1 1>;
140 phy0: ethernet-phy@0 {
148 ralink,mtd-eeprom = <&factory 0x2000>;