2 #include <dt-bindings/interrupt-controller/irq.h>
3 #include <dt-bindings/gpio/gpio.h>
6 compatible = "lantiq,falcon-easy98000", "lantiq,falcon";
9 device_type = "memory";
10 reg = <0x0 0x4000000>;
14 compatible = "gpio-leds";
15 pinctrl-names = "default";
16 pinctrl-0 = <&bootled_pins>;
19 label = "easy98000:green:gpon";
20 gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
21 default-state = "keep";
24 label = "easy98000:red:gpon";
25 gpios = <&gpio0 10 GPIO_ACTIVE_HIGH>;
26 default-state = "keep";
29 label = "easy98000:green:gpon_tx";
30 gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
31 default-state = "keep";
34 label = "easy98000:green:gpon_rx";
35 gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>;
36 default-state = "keep";
39 label = "easy98000:green:voice";
40 gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
41 default-state = "keep";
44 label = "easy98000:green:status";
45 gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
46 default-state = "keep";
52 eth0: ethernet@0000000 {
53 compatible = "davicom,dm9000";
54 device_type = "network";
55 reg = <0x0000003 0x1>, <0x0000001 0x1>;
56 reg-names = "addr", "data";
57 interrupt-parent = <&gpio1>;
58 #interrupt-cells = <2>;
59 interrupts = <10 IRQ_TYPE_LEVEL_LOW>;
60 local-mac-address = [ 00 00 00 00 00 00 ];
64 compatible = "lantiq,easy98000_addon";
65 reg = <0x3c00000 0x2>;
69 compatible = "lantiq,easy98000_cpld_led";
70 reg = <0x3c0000c 0x2>, <0x3c00012 0x2>;
74 /* // enable this for second uart:
83 compatible = "atmel,at25", "atmel,at25160n";
85 spi-max-frequency = <1000000>;
98 clock-frequency = <100000>;
100 /* eeprom-emulation by OMU */
102 compatible = "at,24c02";
106 compatible = "at,24c02";