1 Index: linux-3.18.27/arch/arm/boot/dts/Makefile
2 ===================================================================
3 --- linux-3.18.27.orig/arch/arm/boot/dts/Makefile
4 +++ linux-3.18.27/arch/arm/boot/dts/Makefile
5 @@ -120,6 +120,7 @@ dtb-$(CONFIG_MACH_KIRKWOOD) += kirkwood-
8 kirkwood-ds411slim.dtb \
9 + kirkwood-goflexhome.dtb \
10 kirkwood-goflexnet.dtb \
11 kirkwood-guruplug-server-plus.dtb \
13 Index: linux-3.18.27/arch/arm/boot/dts/kirkwood-goflexhome.dts
14 ===================================================================
16 +++ linux-3.18.27/arch/arm/boot/dts/kirkwood-goflexhome.dts
20 +#include "kirkwood.dtsi"
21 +#include "kirkwood-6281.dtsi"
24 + model = "Seagate GoFlex Home";
25 + compatible = "seagate,goflexhome", "marvell,kirkwood-88f6281", "marvell,kirkwood";
28 + device_type = "memory";
29 + reg = <0x00000000 0x8000000>;
33 + bootargs = "console=ttyS0,115200n8 earlyprintk root=/dev/sda1 rootdelay=10";
34 + stdout-path = &uart0;
38 + pinctrl: pin-controller@10000 {
39 + pmx_usb_power_enable: pmx-usb-power-enable {
40 + marvell,pins = "mpp29";
41 + marvell,function = "gpio";
43 + pmx_led_white: pmx-led-white {
44 + marvell,pins = "mpp40";
45 + marvell,function = "gpio";
47 + pmx_led_green: pmx-led_green {
48 + marvell,pins = "mpp46";
49 + marvell,function = "gpio";
51 + pmx_led_orange: pmx-led-orange {
52 + marvell,pins = "mpp47";
53 + marvell,function = "gpio";
67 + compatible = "gpio-leds";
70 + label = "status:green:health";
71 + gpios = <&gpio1 14 1>;
72 + linux,default-trigger = "default-on";
75 + label = "status:orange:fault";
76 + gpios = <&gpio1 15 1>;
79 + label = "status:white:misc";
80 + gpios = <&gpio1 8 1>;
81 + linux,default-trigger = "ide-disk";
85 + compatible = "simple-bus";
86 + #address-cells = <1>;
88 + pinctrl-0 = <&pmx_usb_power_enable>;
89 + pinctrl-names = "default";
91 + usb_power: regulator@1 {
92 + compatible = "regulator-fixed";
94 + regulator-name = "USB Power";
95 + regulator-min-microvolt = <5000000>;
96 + regulator-max-microvolt = <5000000>;
98 + regulator-always-on;
100 + gpio = <&gpio0 29 GPIO_ACTIVE_HIGH>;
111 + reg = <0x0000000 0x100000>;
117 + reg = <0x100000 0x0ff00000>;
124 + ethphy0: ethernet-phy@0 {
132 + phy-handle = <ðphy0>;