target/linux/ath79/dts/qca9533_ubnt_acb-isp.dts

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2 /dts-v1/;
   3
   4 #include <dt-bindings/gpio/gpio.h>
   5 #include <dt-bindings/input/input.h>
   6
   7 #include "qca953x.dtsi"
   8
   9 / {
  10         compatible = "ubnt,acb-isp", "qca,qca9533";
  11         model = "Ubiquiti airCube ISP";
  12
  13         keys {
  14                 compatible = "gpio-keys";
  15
  16                 reset {
  17                         label = "reset";
  18                         linux,code = <KEY_RESTART>;
  19                         gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
  20                         debounce-interval = <60>;
  21                 };
  22         };
  23 };
  24
  25 &spi {
  26         status = "okay";
  27         num-cs = <1>;
  28
  29         flash@0 {
  30                 compatible = "jedec,spi-nor";
  31                 reg = <0>;
  32                 spi-max-frequency = <25000000>;
  33
  34                 partitions {
  35                         compatible = "fixed-partitions";
  36                         #address-cells = <1>;
  37                         #size-cells = <1>;
  38
  39                         partition@0 {
  40                                 label = "u-boot";
  41                                 reg = <0x000000 0x040000>;
  42                                 read-only;
  43                         };
  44
  45                         partition@40000 {
  46                                 label = "u-boot-env";
  47                                 reg = <0x040000 0x010000>;
  48                                 read-only;
  49                         };
  50
  51                         partition@50000 {
  52                                 compatible = "denx,uimage";
  53                                 label = "firmware";
  54                                 reg = <0x050000 0xf60000>;
  55                         };
  56
  57                         partition@fb0000 {
  58                                 label = "cfg";
  59                                 reg = <0xfb0000 0x040000>;
  60                                 read-only;
  61                         };
  62
  63                         eeprom: partition@ff0000 {
  64                                 label = "EEPROM";
  65                                 reg = <0xff0000 0x010000>;
  66                                 read-only;
  67                         };
  68                 };
  69         };
  70 };
  71
  72 &uart {
  73         status = "okay";
  74 };
  75
  76 &eth0 {
  77         status = "okay";
  78         mtd-mac-address = <&eeprom 0x0>;
  79         phy-handle = <&swphy4>;
  80 };
  81
  82 &eth1 {
  83         status = "okay";
  84         mtd-mac-address = <&eeprom 0x6>;
  85
  86         gmac-config {
  87                 device = <&gmac>;
  88         };
  89 };
  90
  91 &wmac {
  92         status = "okay";
  93         mtd-cal-data = <&eeprom 0x1000>;
  94         mtd-mac-address = <&eeprom 0x1002>;
  95 };