target/linux/ath79/dts/ar9331_glinet_64xx.dtsi

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include <dt-bindings/gpio/gpio.h>
   4 #include <dt-bindings/input/input.h>
   5
   6 #include "ar9331.dtsi"
   7
   8 / {
   9         aliases {
  10                 serial0 = &uart;
  11                 label-mac-device = &wmac;
  12         };
  13
  14         keys {
  15                 compatible = "gpio-keys";
  16
  17                 reset {
  18                         label = "reset";
  19                         linux,code = <KEY_RESTART>;
  20                         gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
  21                         debounce-interval = <60>;
  22                 };
  23         };
  24
  25         leds {
  26                 compatible = "gpio-leds";
  27
  28                 wlan {
  29                         label = "gl-inet:red:wlan";
  30                         gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
  31                         linux,default-trigger = "phy0tpt";
  32                 };
  33
  34                 lan {
  35                         label = "gl-inet:green:lan";
  36                         gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
  37                 };
  38         };
  39
  40         reg_usb_vbus: reg_usb_vbus {
  41                 compatible = "regulator-fixed";
  42                 regulator-name = "usb_vbus";
  43                 regulator-min-microvolt = <5000000>;
  44                 regulator-max-microvolt = <5000000>;
  45                 enable-active-high;
  46         };
  47 };
  48
  49 &eth0 {
  50         status = "okay";
  51
  52         mtd-mac-address = <&uboot 0x1fc00>;
  53
  54         gmac-config {
  55                 device = <&gmac>;
  56
  57                 switch-phy-addr-swap = <0>;
  58                 switch-phy-swap = <0>;
  59         };
  60 };
  61
  62 &eth1 {
  63         status = "okay";
  64
  65         mtd-mac-address = <&uboot 0x1fc00>;
  66 };
  67
  68 &gpio {
  69         status = "okay";
  70 };
  71
  72 &uart {
  73         status = "okay";
  74 };
  75
  76 &usb {
  77         dr_mode = "host";
  78         vbus-supply = <&reg_usb_vbus>;
  79         status = "okay";
  80 };
  81
  82 &usb_phy {
  83         status = "okay";
  84 };
  85
  86 &wmac {
  87         status = "okay";
  88
  89         mtd-cal-data = <&art 0x1000>;
  90         mtd-mac-address = <&uboot 0x1fc00>;
  91 };