target/linux/ath79/dts/ar9331_alfa-network_ap121f.dts

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2 /dts-v1/;
   3
   4 #include <dt-bindings/gpio/gpio.h>
   5 #include <dt-bindings/input/input.h>
   6
   7 #include "ar9331.dtsi"
   8
   9 / {
  10         model = "ALFA Network AP121F";
  11         compatible = "alfa-network,ap121f", "qca,ar9331";
  12
  13         aliases {
  14                 label-mac-device = &wmac;
  15                 led-boot = &vpn;
  16                 led-failsafe = &vpn;
  17                 led-upgrade = &vpn;
  18                 serial0 = &uart;
  19         };
  20
  21         keys {
  22                 compatible = "gpio-keys";
  23
  24                 reset {
  25                         label = "reset";
  26                         linux,code = <KEY_RESTART>;
  27                         gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
  28                 };
  29
  30                 switch {
  31                         label = "switch";
  32                         linux,code = <BTN_0>;
  33                         gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
  34                 };
  35         };
  36
  37         leds {
  38                 compatible = "gpio-leds";
  39
  40                 lan {
  41                         label = "ap121f:green:lan";
  42                         gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
  43                 };
  44
  45                 vpn: vpn {
  46                         label = "ap121f:green:vpn";
  47                         gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
  48                 };
  49
  50                 wlan {
  51                         label = "ap121f:green:wlan";
  52                         gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
  53                         linux,default-trigger = "phy0tpt";
  54                 };
  55         };
  56 };
  57
  58 &eth0 {
  59         status = "okay";
  60         mtd-mac-address = <&art 0x0>;
  61
  62         gmac-config {
  63                 device = <&gmac>;
  64                 switch-phy-addr-swap = <0>;
  65                 switch-phy-swap = <0>;
  66         };
  67 };
  68
  69 &eth1 {
  70         status = "okay";
  71         compatible = "syscon", "simple-mfd";
  72 };
  73
  74 &gpio {
  75         status = "okay";
  76 };
  77
  78 &spi {
  79         status = "okay";
  80         num-cs = <1>;
  81
  82         flash@0 {
  83                 compatible = "jedec,spi-nor";
  84                 reg = <0>;
  85                 spi-max-frequency = <25000000>;
  86
  87                 partitions {
  88                         compatible = "fixed-partitions";
  89                         #address-cells = <1>;
  90                         #size-cells = <1>;
  91
  92                         partition@0 {
  93                                 label = "u-boot";
  94                                 reg = <0x000000 0x030000>;
  95                                 read-only;
  96                         };
  97
  98                         partition@30000 {
  99                                 label = "u-boot-env";
 100                                 reg = <0x030000 0x010000>;
 101                         };
 102
 103                         art: partition@40000 {
 104                                 label = "art";
 105                                 reg = <0x040000 0x010000>;
 106                                 read-only;
 107                         };
 108
 109                         partition@50000 {
 110                                 compatible = "denx,uimage";
 111                                 label = "firmware";
 112                                 reg = <0x050000 0xfb0000>;
 113                         };
 114                 };
 115         };
 116 };
 117
 118 &uart {
 119         status = "okay";
 120 };
 121
 122 &usb {
 123         status = "okay";
 124         dr_mode = "host";
 125 };
 126
 127 &usb_phy {
 128         status = "okay";
 129 };
 130
 131 &wmac {
 132         status = "okay";
 133         mtd-cal-data = <&art 0x1000>;
 134 };