include/configs/ls1012a_common.h

   1 /*
   2  * Copyright 2016 Freescale Semiconductor
   3  *
   4  * SPDX-License-Identifier:     GPL-2.0+
   5  */
   6
   7 #ifndef __LS1012A_COMMON_H
   8 #define __LS1012A_COMMON_H
   9
  10 #define CONFIG_FSL_LAYERSCAPE
  11 #define CONFIG_GICV2
  12
  13 #include <asm/arch/config.h>
  14 #include <asm/arch/stream_id_lsch2.h>
  15
  16 #define CONFIG_SUPPORT_RAW_INITRD
  17
  18 #define CONFIG_DISPLAY_BOARDINFO_LATE
  19
  20 #define CONFIG_SYS_CLK_FREQ             125000000
  21
  22 #define CONFIG_SKIP_LOWLEVEL_INIT
  23
  24 #define CONFIG_SYS_INIT_SP_ADDR         (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
  25 #define CONFIG_SYS_LOAD_ADDR    (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
  26
  27 #define CONFIG_SYS_DDR_SDRAM_BASE       0x80000000
  28 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY       0
  29 #define CONFIG_SYS_SDRAM_BASE           CONFIG_SYS_DDR_SDRAM_BASE
  30 #define CONFIG_SYS_DDR_BLOCK2_BASE     0x880000000ULL
  31
  32 /* Generic Timer Definitions */
  33 #define COUNTER_FREQUENCY               25000000        /* 25MHz */
  34
  35 /* CSU */
  36 #define CONFIG_LAYERSCAPE_NS_ACCESS
  37
  38 /* Size of malloc() pool */
  39 #define CONFIG_SYS_MALLOC_LEN           (CONFIG_ENV_SIZE + 128 * 1024)
  40
  41 /*SPI device */
  42 #ifdef CONFIG_QSPI_BOOT
  43 #define CONFIG_SYS_QE_FW_IN_SPIFLASH
  44 #define CONFIG_SYS_FMAN_FW_ADDR         0x400d0000
  45 #define CONFIG_ENV_SPI_BUS              0
  46 #define CONFIG_ENV_SPI_CS               0
  47 #define CONFIG_ENV_SPI_MAX_HZ           1000000
  48 #define CONFIG_ENV_SPI_MODE             0x03
  49 #define CONFIG_SPI_FLASH_SPANSION
  50 #define CONFIG_FSL_SPI_INTERFACE
  51 #define CONFIG_SF_DATAFLASH
  52
  53 #define CONFIG_FSL_QSPI
  54 #define QSPI0_AMBA_BASE         0x40000000
  55 #define CONFIG_SPI_FLASH_SPANSION
  56
  57 #define FSL_QSPI_FLASH_SIZE             SZ_64M
  58 #define FSL_QSPI_FLASH_NUM              2
  59
  60 /*
  61  * Environment
  62  */
  63 #define CONFIG_ENV_OVERWRITE
  64
  65 #define CONFIG_ENV_SIZE                 0x40000          /* 256KB */
  66 #define CONFIG_ENV_OFFSET               0x300000        /* 3MB */
  67 #define CONFIG_ENV_SECT_SIZE            0x40000
  68 #endif
  69
  70 /* SATA */
  71 #define CONFIG_SCSI_AHCI_PLAT
  72
  73 #define CONFIG_SYS_SATA                         AHCI_BASE_ADDR
  74
  75 #define CONFIG_SYS_SCSI_MAX_SCSI_ID             1
  76 #define CONFIG_SYS_SCSI_MAX_LUN                 1
  77 #define CONFIG_SYS_SCSI_MAX_DEVICE              (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
  78                                                 CONFIG_SYS_SCSI_MAX_LUN)
  79
  80 /* I2C */
  81 #define CONFIG_SYS_I2C
  82 #define CONFIG_SYS_I2C_MXC
  83 #define CONFIG_SYS_I2C_MXC_I2C1         /* enable I2C bus 1 */
  84 #define CONFIG_SYS_I2C_MXC_I2C2         /* enable I2C bus 2 */
  85
  86 #define CONFIG_CONS_INDEX       1
  87 #define CONFIG_SYS_NS16550_SERIAL
  88 #define CONFIG_SYS_NS16550_REG_SIZE     1
  89 #define CONFIG_SYS_NS16550_CLK          (get_serial_clock())
  90
  91 #define CONFIG_SYS_BAUDRATE_TABLE       { 9600, 19200, 38400, 57600, 115200 }
  92
  93 #define CONFIG_SYS_HZ                   1000
  94
  95 #define CONFIG_HWCONFIG
  96 #define HWCONFIG_BUFFER_SIZE            128
  97
  98 #include <config_distro_defaults.h>
  99 #ifndef CONFIG_SPL_BUILD
 100 #define BOOT_TARGET_DEVICES(func) \
 101         func(SCSI, scsi, 0) \
 102         func(MMC, mmc, 0) \
 103         func(USB, usb, 0)
 104 #include <config_distro_bootcmd.h>
 105 #endif
 106
 107 /* Initial environment variables */
 108 #define CONFIG_EXTRA_ENV_SETTINGS               \
 109         "verify=no\0"                           \
 110         "loadaddr=0x80100000\0"                 \
 111         "kernel_addr=0x100000\0"                \
 112         "fdt_high=0xffffffffffffffff\0"         \
 113         "initrd_high=0xffffffffffffffff\0"      \
 114         "kernel_start=0x1000000\0"              \
 115         "kernel_load=0xa0000000\0"              \
 116         "kernel_size=0x2800000\0"               \
 117
 118 #undef CONFIG_BOOTCOMMAND
 119 #define CONFIG_BOOTCOMMAND              "sf probe 0:0; sf read $kernel_load "\
 120                                         "$kernel_start $kernel_size && "\
 121                                         "bootm $kernel_load"
 122
 123 /* Monitor Command Prompt */
 124 #define CONFIG_SYS_CBSIZE               512     /* Console I/O Buffer Size */
 125 #define CONFIG_SYS_LONGHELP
 126 #define CONFIG_AUTO_COMPLETE
 127 #define CONFIG_SYS_MAXARGS              64      /* max command args */
 128
 129 #define CONFIG_SYS_BOOTM_LEN   (64 << 20)      /* Increase max gunzip size */
 130
 131 #include <asm/arch/soc.h>
 132
 133 #endif /* __LS1012A_COMMON_H */