2 * (C) Copyright 2005, Psyent Corporation <www.psyent.com>
3 * Scott McNutt <smcnutt@psyent.com>
4 * (C) Copyright 2010, Thomas Chou <thomas@wytron.com.tw>
6 * SPDX-License-Identifier: GPL-2.0+
15 #define CONFIG_DISPLAY_CPUINFO
16 #define CONFIG_DISPLAY_BOARDINFO_LATE
21 #define CONFIG_BAUDRATE 115200
22 #define CONFIG_SYS_CONSOLE_INFO_QUIET /* Suppress console info */
23 #define CONFIG_SYS_NS16550_MEM32
28 #define CONFIG_SYS_MAX_FLASH_BANKS 1
29 #define CONFIG_SYS_MAX_FLASH_SECT 1024
30 #define CONFIG_MTD_DEVICE
35 #define CONFIG_SYS_RX_ETH_BUFFER 0
36 #define CONFIG_CMD_MII
37 #define CONFIG_PHY_GIGE
38 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
39 #define CONFIG_PHY_MARVELL
44 #define CONFIG_BOOTP_BOOTFILESIZE
45 #define CONFIG_BOOTP_BOOTPATH
46 #define CONFIG_BOOTP_GATEWAY
47 #define CONFIG_BOOTP_HOSTNAME
52 #define CONFIG_OF_LIBFDT
53 #define CONFIG_OF_BOARD_SETUP
57 * ENVIRONMENT -- Put environment in sector CONFIG_SYS_MONITOR_LEN above
58 * CONFIG_SYS_RESET_ADDR, since we assume the monitor is stored at the
59 * reset address, no? This will keep the environment in user region
60 * of flash. NOTE: the monitor length must be multiple of sector size
61 * (which is common practice).
63 #define CONFIG_ENV_IS_IN_FLASH
65 #define CONFIG_ENV_SIZE 0x10000 /* 64k, 1 sector */
66 #define CONFIG_ENV_OVERWRITE /* Serial change Ok */
67 #define CONFIG_ENV_ADDR 0xf4040000
71 * -Monitor at top of sdram.
72 * -The heap is placed below the monitor
73 * -The stack is placed below the heap (&grows down).
75 #define CONFIG_SYS_SDRAM_BASE 0xc8000000
76 #define CONFIG_SYS_SDRAM_SIZE 0x08000000
77 #define CONFIG_NR_DRAM_BANKS 1
78 #define CONFIG_MONITOR_IS_IN_RAM
79 #define CONFIG_SYS_MONITOR_LEN 0x40000 /* Reserve 256k */
80 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_SDRAM_BASE + \
81 CONFIG_SYS_SDRAM_SIZE - \
82 CONFIG_SYS_MONITOR_LEN)
83 #define CONFIG_SYS_MALLOC_LEN 0x20000
88 #define CONFIG_SYS_LONGHELP /* Provide extended help */
89 #define CONFIG_SYS_CBSIZE 256 /* Console I/O buf size */
90 #define CONFIG_SYS_MAXARGS 16 /* Max command args */
91 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Bootarg buf size */
92 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
93 sizeof(CONFIG_SYS_PROMPT) + \
94 16) /* Print buf size */
95 #define CONFIG_SYS_LOAD_ADDR CONFIG_SYS_SDRAM_BASE
96 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE
97 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MONITOR_BASE - \
99 CONFIG_SYS_MALLOC_LEN - \
101 #define CONFIG_CMDLINE_EDITING
103 #endif /* __CONFIG_H */