1 source "drivers/net/phy/Kconfig"
2 source "drivers/net/pfe_eth/Kconfig"
5 bool "Enable Driver Model for Ethernet drivers"
8 Enable driver model for Ethernet.
10 The eth_*() interface will be implemented by the UC_ETH class
11 This is currently implemented in net/eth.c
12 Look in include/net.h for details.
15 bool "TI Common Platform Ethernet Switch"
18 This driver supports the TI three port switch gigabit ethernet
19 subsystem found in the TI SoCs.
22 bool "Network device support"
26 You must select Y to enable any network device support
27 Generally if you have any networking support this is a given
34 bool "Enable GbE PHY status parsing and configuration"
36 Enables support for parsing the status output and for
37 configuring GbE PHYs (affects the inner workings of some
38 commands and miiphyutil.c).
41 bool "Atheros AG7xxx Ethernet MAC support"
42 depends on DM_ETH && ARCH_ATH79
45 This driver supports the Atheros AG7xxx Ethernet MAC. This MAC is
46 present in the Atheros AR7xxx, AR9xxx and QCA9xxx MIPS chips.
50 bool "Altera Triple-Speed Ethernet MAC support"
54 This driver supports the Altera Triple-Speed (TSE) Ethernet MAC.
55 Please find details on the "Triple-Speed Ethernet MegaCore Function
56 Resource Center" of Altera.
59 bool "Broadcom SF2 (Starfighter2) Ethernet support"
62 This is an abstract framework which provides a generic interface
63 to MAC and DMA management for multiple Broadcom SoCs such as
64 Cygnus, NSP and bcm28155_ap platforms.
66 config BCM_SF2_ETH_DEFAULT_PORT
67 int "Broadcom SF2 (Starfighter2) Ethernet default port number"
68 depends on BCM_SF2_ETH
71 Default port number for the Starfighter2 ethernet driver.
73 config BCM_SF2_ETH_GMAC
74 bool "Broadcom SF2 (Starfighter2) GMAC Ethernet support"
75 depends on BCM_SF2_ETH
77 This flag enables the ethernet support for Broadcom platforms with
78 GMAC such as Cygnus. This driver is based on the framework provided
79 by the BCM_SF2_ETH driver.
80 Say Y to any bcmcygnus based platforms.
83 bool "Synopsys DWC Ethernet QOS device support"
87 This driver supports the Synopsys Designware Ethernet QOS (Quality
88 Of Service) IP block. The IP supports many options for bus type,
89 clocking/reset structure, and feature list. This driver currently
90 supports the specific configuration used in NVIDIA's Tegra186 chip,
91 but should be extensible to other combinations quite easily.
94 bool "Intel PRO/1000 Gigabit Ethernet support"
96 This driver supports Intel(R) PRO/1000 gigabit ethernet family of
97 adapters. For more information on how to identify your adapter, go
98 to the Adapter & Driver ID Guide at:
100 <http://support.intel.com/support/network/adapter/pro100/21397.htm>
102 config E1000_SPI_GENERIC
103 bool "Allow access to the Intel 8257x SPI bus"
106 Allow generic access to the SPI bus on the Intel 8257x, for
107 example with the "sspi" command.
110 bool "Enable SPI bus utility code"
113 Utility code for direct access to the SPI bus on Intel 8257x.
114 This does not do anything useful unless you set at least one
115 of CONFIG_CMD_E1000 or CONFIG_E1000_SPI_GENERIC.
118 bool "Enable the e1000 command"
121 This enables the 'e1000' management command for E1000 devices. When
122 used on devices with SPI support you can reprogram the EEPROM from
126 depends on DM_ETH && SANDBOX
128 bool "Sandbox: Mocked Ethernet driver"
130 This driver simply responds with fake ARP replies and ping
131 replies that are used to verify network stack functionality
133 This driver is particularly useful in the test/dm/eth.c tests
135 config ETH_SANDBOX_RAW
136 depends on DM_ETH && SANDBOX
138 bool "Sandbox: Bridge to Linux Raw Sockets"
140 This driver is a bridge from the bottom of the network stack
141 in U-Boot to the RAW AF_PACKET API in Linux. This allows real
142 network traffic to be tested from within sandbox. See
143 board/sandbox/README.sandbox for more details.
145 config ETH_DESIGNWARE
146 bool "Synopsys Designware Ethernet MAC"
149 This MAC is present in SoCs from various vendors. It supports
150 100Mbit and 1 Gbit operation. You must enable CONFIG_PHYLIB to
151 provide the PHY (physical media interface).
154 bool "OpenCores 10/100 Mbps Ethernet MAC"
156 This MAC is present in OpenRISC and Xtensa XTFPGA boards.
159 bool "FEC Ethernet controller"
160 depends on MX5 || MX6
162 This driver supports the 10/100 Fast Ethernet controller for
166 bool "Ftmac100 Ethernet Support"
168 This MAC is present in Andestech SoCs.
171 bool "Marvell Armada XP/385/3700 network interface support"
172 depends on ARMADA_XP || ARMADA_38X || ARMADA_3700
175 This driver supports the network interface units in the
176 Marvell ARMADA XP, ARMADA 38X and ARMADA 3700 SoCs
179 bool "Marvell Armada 375/7K/8K network interface support"
180 depends on ARMADA_375 || ARMADA_8K
183 This driver supports the network interface units in the
184 Marvell ARMADA 375, 7K and 8K SoCs.
187 bool "Cadence MACB/GEM Ethernet Interface"
191 The Cadence MACB ethernet interface is found on many Atmel
192 AT91 and SAMA5 parts. This driver also supports the Cadence
193 GEM (Gigabit Ethernet MAC) found in some ARM SoC devices.
194 Say Y to include support for the MACB/GEM chip.
197 bool "Cadence MACB/GEM Ethernet Interface for Xilinx Zynq"
200 The Cadence MACB ethernet interface was used on Zynq platform.
201 Say Y to enable support for the MACB/GEM in Zynq chip.
204 bool "Intel Platform Controller Hub EG20T GMAC driver"
205 depends on DM_ETH && DM_PCI
208 This MAC is present in Intel Platform Controller Hub EG20T. It
209 supports 10/100/1000 Mbps operation.
214 Enable the support of the Reduced Gigabit Media-Independent
218 bool "Realtek 8139 series Ethernet controller driver"
220 This driver supports Realtek 8139 series fast ethernet family of
221 PCI chipsets/adapters.
224 bool "Realtek 8169 series Ethernet controller driver"
226 This driver supports Realtek 8169 series gigabit ethernet family of
227 PCI/PCIe chipsets/adapters.
230 bool "SMSC LAN911x and LAN921x controller driver"
235 hex "SMC911X Base Address"
237 Define this to hold the physical address
238 of the device (I/O space)
241 prompt "SMC911X bus width"
242 default SMC911X_16_BIT
244 config SMC911X_32_BIT
245 bool "Enable 32-bit interface"
247 config SMC911X_16_BIT
248 bool "Enable 16-bit interface"
250 Define this if data bus is 16 bits. If your processor
251 automatically converts one 32 bit word to two 16 bit
252 words you may also try CONFIG_SMC911X_32_BIT.
258 bool "Enable Allwinner GMAC Ethernet support"
260 Enable the support for Sun7i GMAC Ethernet controller
262 config SUN7I_GMAC_FORCE_TXERR
263 bool "Force PA17 as gmac function"
264 depends on SUN7I_GMAC
266 Some ethernet phys needs TXERR control. Since the GMAC
267 doesn't have such signal, setting PA17 as GMAC function
268 makes the pin output low, which enables data transmission.
271 bool "Allwinner Sun4i Ethernet MAC support"
275 This driver supports the Allwinner based SUN4I Ethernet MAC.
278 bool "Allwinner Sun8i Ethernet MAC support"
283 This driver supports the Allwinner based SUN8I/SUN50I Ethernet MAC.
284 It can be found in H3/A64/A83T based SoCs and compatible with both
285 External and Internal PHYs.
288 bool "Renesas SH Ethernet MAC"
291 This driver supports the Ethernet for Renesas SH and ARM SoCs.
293 config XILINX_AXIEMAC
294 depends on DM_ETH && (MICROBLAZE || ARCH_ZYNQ || ARCH_ZYNQMP)
297 bool "Xilinx AXI Ethernet"
299 This MAC is present in Xilinx Microblaze, Zynq and ZynqMP SoCs.
301 config XILINX_EMACLITE
302 depends on DM_ETH && (MICROBLAZE || ARCH_ZYNQ || ARCH_ZYNQMP || MIPS)
305 bool "Xilinx Ethernetlite"
307 This MAC is present in Xilinx Microblaze, Zynq and ZynqMP SoCs.
310 depends on DM_ETH && (ARCH_ZYNQ || ARCH_ZYNQMP)
312 bool "Xilinx Ethernet GEM"
314 This MAC is present in Xilinx Zynq and ZynqMP SoCs.
317 bool "Microchip PIC32 Ethernet Support"
318 depends on DM_ETH && MACH_PIC32
321 This driver implements 10/100 Mbps Ethernet and MAC layer for
322 Microchip PIC32 microcontrollers.
325 bool "Rockchip Synopsys Designware Ethernet MAC"
326 depends on DM_ETH && ETH_DESIGNWARE
328 This driver provides Rockchip SoCs network support based on the
329 Synopsys Designware driver.
332 bool "Renesas Ethernet AVB MAC"
333 depends on DM_ETH && RCAR_GEN3
336 This driver implements support for the Ethernet AVB block in
337 Renesas M3 and H3 SoCs.
340 bool "Fast Ethernet Controller on MPC8XX"
344 This driver implements support for the Fast Ethernet Controller
349 depends on MPC8XX_FEC
354 depends on ETHER_ON_FEC1
357 Define to the hardcoded PHY address which corresponds
358 to the given FEC; i. e.
359 #define CONFIG_FEC1_PHY 4
360 means that the PHY with address 4 is connected to FEC1
362 When set to -1, means to probe for first available.
366 depends on ETHER_ON_FEC1
369 The PHY does not have a RXERR line (RMII only).
370 (so program the FEC to ignore it).
374 depends on MPC8XX_FEC && MPC885
379 depends on ETHER_ON_FEC2
382 Define to the hardcoded PHY address which corresponds
383 to the given FEC; i. e.
384 #define CONFIG_FEC1_PHY 4
385 means that the PHY with address 4 is connected to FEC1
387 When set to -1, means to probe for first available.
389 config FEC2_PHY_NORXERR
391 depends on ETHER_ON_FEC2
394 The PHY does not have a RXERR line (RMII only).
395 (so program the FEC to ignore it).
397 config SYS_DPAA_QBMAN
398 bool "Device tree fixup for QBMan on freescale SOCs"
399 depends on (ARM || PPC) && !SPL_BUILD
400 default y if ARCH_B4860 || \
419 QBman fixups to allow deep sleep in DPAA 1 SOCs
423 bool "Enable Three-Speed Ethernet Controller"
425 This driver implements support for the (Enhanced) Three-Speed
426 Ethernet Controller found on Freescale SoCs.