x86: qemu: Report high memory in the E820 table
[oweals/u-boot.git] / doc / SPI / README.ti_qspi_dra_test
1 -------------------------------------------------
2    Simple steps used to test the QSPI at U-Boot
3 -------------------------------------------------
4
5 For #1, build the patched U-Boot and load MLO/u-boot.img
6
7 ----------------------------------
8 Boot from another medium like MMC
9 ----------------------------------
10
11 U-Boot# mmc dev 0
12 mmc0 is current device
13 U-Boot# fatload mmc 0 0x82000000 MLO
14 reading MLO
15 55872 bytes read in 8 ms (6.7 MiB/s)
16 U-Boot# fatload mmc 0 0x83000000 u-boot.img
17 reading u-boot.img
18 248600 bytes read in 19 ms (12.5 MiB/s)
19
20 --------------------------------------------------
21 Commands to erase/write u-boot/mlo to flash device
22 --------------------------------------------------
23 U-Boot# sf probe 0
24 SF: Detected S25FL256S_64K with page size 256 Bytes, erase size 64 KiB, total 32 MiB, mapped at 5c000000
25 U-Boot# sf erase 0 0x10000
26 SF: 65536 bytes @ 0x0 Erased: OK
27 U-Boot# sf erase 0x20000 0x10000
28 SF: 65536 bytes @ 0x20000 Erased: OK
29 U-Boot# sf erase 0x30000 0x10000
30 SF: 65536 bytes @ 0x30000 Erased: OK
31 U-Boot# sf erase 0x40000 0x10000
32 SF: 65536 bytes @ 0x40000 Erased: OK
33 U-Boot# sf erase 0x50000 0x10000
34 SF: 65536 bytes @ 0x50000 Erased: OK
35 U-Boot# sf erase 0x60000 0x10000
36 SF: 65536 bytes @ 0x60000 Erased: OK
37 U-Boot# sf write 82000000 0 0x10000
38 SF: 65536 bytes @ 0x0 Written: OK
39 U-Boot# sf write 83000000 0x20000 0x60000
40 SF: 393216 bytes @ 0x20000 Written: OK
41
42 For #2, set sysboot to QSPI-1 boot mode(SYSBOOT[5:0] = 100110) and power
43 on. ROM should find the GP header at offset 0 and load/execute SPL. SPL
44 then detects that ROM was in QSPI-1 mode (boot code 10) and attempts to
45 find a U-Boot image header at offset 0x20000 (set in the config file)
46 and proceeds to load that image using the U-Boot image payload offset/size
47 from the header. It will then start U-Boot.