3 * Avionic Design GmbH <www.avionic-design.de>
5 * SPDX-License-Identifier: GPL-2.0+
9 #include <asm/arch/pinmux.h>
10 #include <asm/arch/gp_padctrl.h>
11 #include <asm/arch/gpio.h>
13 #include "pinmux-config-tamonten-ng.h"
16 #define PMU_I2C_ADDRESS 0x2D
18 #define PMU_REG_LDO5 0x32
20 #define PMU_REG_LDO_HIGH_POWER 1
22 /* Voltage selection for the LDOs with 100mV resolution */
23 #define PMU_REG_LDO_SEL_100(mV) ((((mV - 1000) / 100) + 2) << 2)
25 #define PMU_REG_LDO_100(st, mV) (PMU_REG_LDO_##st | PMU_REG_LDO_SEL_100(mV))
27 #define PMU_LDO5(st, mV) PMU_REG_LDO_100(st, mV)
29 void pinmux_init(void)
31 pinmux_config_pingrp_table(tamonten_ng_pinmux_common,
32 ARRAY_SIZE(tamonten_ng_pinmux_common));
33 pinmux_config_pingrp_table(unused_pins_lowpower,
34 ARRAY_SIZE(unused_pins_lowpower));
36 /* Initialize any non-default pad configs (APB_MISC_GP regs) */
37 pinmux_config_drvgrp_table(tamonten_ng_padctrl,
38 ARRAY_SIZE(tamonten_ng_padctrl));
41 void gpio_early_init(void)
43 /* Turn on the alive signal */
44 gpio_request(GPIO_PV2, "ALIVE");
45 gpio_direction_output(GPIO_PV2, 1);
47 /* Remove the reset on the external periph */
48 gpio_request(GPIO_PI4, "nRST_PERIPH");
49 gpio_direction_output(GPIO_PI4, 1);
52 void pmu_write(uchar reg, uchar data)
54 i2c_set_bus_num(4); /* PMU is on bus 4 */
55 i2c_write(PMU_I2C_ADDRESS, reg, 1, &data, 1);
59 * Do I2C/PMU writes to bring up SD card bus power
62 void board_sdmmc_voltage_init(void)
64 /* Enable LDO5 with 3.3v for SDMMC3 */
65 pmu_write(PMU_REG_LDO5, PMU_LDO5(HIGH_POWER, 3300));
67 /* Switch the power on */
68 gpio_request(GPIO_PJ2, "EN_3V3_EMMC");
69 gpio_direction_output(GPIO_PJ2, 1);
73 * Routine: pin_mux_mmc
74 * Description: setup the MMC muxes, power rails, etc.
76 void pin_mux_mmc(void)
79 * NOTE: We don't do mmc-specific pin muxes here.
80 * They were done globally in pinmux_init().
83 /* Bring up the SDIO1 power rail */
84 board_sdmmc_voltage_init();