1 // SPDX-License-Identifier: GPL-2.0+
3 * (C) Copyright 2007-2008
4 * Stelian Pop <stelian@popies.net>
5 * Lead Tech Design <www.leadtechdesign.com>
9 #include <debug_uart.h>
13 #include <linux/sizes.h>
14 #include <asm/arch/at91sam9263.h>
15 #include <asm/arch/at91sam9_smc.h>
16 #include <asm/arch/at91_common.h>
17 #include <asm/arch/at91_matrix.h>
18 #include <asm/arch/at91_pio.h>
19 #include <asm/arch/clk.h>
21 #include <asm/arch/gpio.h>
22 #include <asm/arch/hardware.h>
24 #include <atmel_lcdc.h>
25 #include <asm/mach-types.h>
27 DECLARE_GLOBAL_DATA_PTR;
29 /* ------------------------------------------------------------------------- */
31 * Miscelaneous platform dependent initialisations
34 #ifdef CONFIG_CMD_NAND
35 static void at91sam9263ek_nand_hw_init(void)
38 at91_smc_t *smc = (at91_smc_t *) ATMEL_BASE_SMC0;
39 at91_matrix_t *matrix = (at91_matrix_t *) ATMEL_BASE_MATRIX;
42 csa = readl(&matrix->csa[0]) | AT91_MATRIX_CSA_EBI_CS3A;
43 writel(csa, &matrix->csa[0]);
47 /* Configure SMC CS3 for NAND/SmartMedia */
48 writel(AT91_SMC_SETUP_NWE(1) | AT91_SMC_SETUP_NCS_WR(0) |
49 AT91_SMC_SETUP_NRD(1) | AT91_SMC_SETUP_NCS_RD(0),
52 writel(AT91_SMC_PULSE_NWE(3) | AT91_SMC_PULSE_NCS_WR(3) |
53 AT91_SMC_PULSE_NRD(3) | AT91_SMC_PULSE_NCS_RD(3),
56 writel(AT91_SMC_CYCLE_NWE(5) | AT91_SMC_CYCLE_NRD(5),
58 writel(AT91_SMC_MODE_RM_NRD | AT91_SMC_MODE_WM_NWE |
59 AT91_SMC_MODE_EXNW_DISABLE |
60 #ifdef CONFIG_SYS_NAND_DBW_16
61 AT91_SMC_MODE_DBW_16 |
62 #else /* CONFIG_SYS_NAND_DBW_8 */
65 AT91_SMC_MODE_TDF_CYCLE(2),
68 at91_periph_clk_enable(ATMEL_ID_PIOA);
69 at91_periph_clk_enable(ATMEL_ID_PIOCDE);
71 /* Configure RDY/BSY */
72 at91_set_gpio_input(CONFIG_SYS_NAND_READY_PIN, 1);
74 /* Enable NandFlash */
75 at91_set_gpio_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
80 vidinfo_t panel_info = {
84 .vl_sync = ATMEL_LCDC_INVLINE_INVERTED |
85 ATMEL_LCDC_INVFRAME_INVERTED,
90 .vl_right_margin = 33,
94 .mmio = ATMEL_BASE_LCDC,
99 at91_set_pio_value(AT91_PIO_PORTA, 30, 1); /* power up */
102 void lcd_disable(void)
104 at91_set_pio_value(AT91_PIO_PORTA, 30, 0); /* power down */
107 static void at91sam9263ek_lcd_hw_init(void)
109 at91_set_a_periph(AT91_PIO_PORTC, 1, 0); /* LCDHSYNC */
110 at91_set_a_periph(AT91_PIO_PORTC, 2, 0); /* LCDDOTCK */
111 at91_set_a_periph(AT91_PIO_PORTC, 3, 0); /* LCDDEN */
112 at91_set_b_periph(AT91_PIO_PORTB, 9, 0); /* LCDCC */
113 at91_set_a_periph(AT91_PIO_PORTC, 6, 0); /* LCDD2 */
114 at91_set_a_periph(AT91_PIO_PORTC, 7, 0); /* LCDD3 */
115 at91_set_a_periph(AT91_PIO_PORTC, 8, 0); /* LCDD4 */
116 at91_set_a_periph(AT91_PIO_PORTC, 9, 0); /* LCDD5 */
117 at91_set_a_periph(AT91_PIO_PORTC, 10, 0); /* LCDD6 */
118 at91_set_a_periph(AT91_PIO_PORTC, 11, 0); /* LCDD7 */
119 at91_set_a_periph(AT91_PIO_PORTC, 14, 0); /* LCDD10 */
120 at91_set_a_periph(AT91_PIO_PORTC, 15, 0); /* LCDD11 */
121 at91_set_a_periph(AT91_PIO_PORTC, 16, 0); /* LCDD12 */
122 at91_set_b_periph(AT91_PIO_PORTC, 12, 0); /* LCDD13 */
123 at91_set_a_periph(AT91_PIO_PORTC, 18, 0); /* LCDD14 */
124 at91_set_a_periph(AT91_PIO_PORTC, 19, 0); /* LCDD15 */
125 at91_set_a_periph(AT91_PIO_PORTC, 22, 0); /* LCDD18 */
126 at91_set_a_periph(AT91_PIO_PORTC, 23, 0); /* LCDD19 */
127 at91_set_a_periph(AT91_PIO_PORTC, 24, 0); /* LCDD20 */
128 at91_set_b_periph(AT91_PIO_PORTC, 17, 0); /* LCDD21 */
129 at91_set_a_periph(AT91_PIO_PORTC, 26, 0); /* LCDD22 */
130 at91_set_a_periph(AT91_PIO_PORTC, 27, 0); /* LCDD23 */
132 at91_periph_clk_enable(ATMEL_ID_LCDC);
133 gd->fb_base = ATMEL_BASE_SRAM0;
136 #ifdef CONFIG_LCD_INFO
140 #ifdef CONFIG_MTD_NOR_FLASH
141 extern flash_info_t flash_info[];
144 void lcd_show_board_info(void)
146 ulong dram_size, nand_size;
147 #ifdef CONFIG_MTD_NOR_FLASH
153 lcd_printf ("%s\n", U_BOOT_VERSION);
154 lcd_printf ("(C) 2008 ATMEL Corp\n");
155 lcd_printf ("at91support@atmel.com\n");
156 lcd_printf ("%s CPU at %s MHz\n",
158 strmhz(temp, get_cpu_clk_rate()));
161 for (i = 0; i < CONFIG_NR_DRAM_BANKS; i++)
162 dram_size += gd->bd->bi_dram[i].size;
164 for (i = 0; i < CONFIG_SYS_MAX_NAND_DEVICE; i++)
165 nand_size += get_nand_dev_by_index(i)->size;
166 #ifdef CONFIG_MTD_NOR_FLASH
168 for (i = 0; i < CONFIG_SYS_MAX_FLASH_BANKS; i++)
169 flash_size += flash_info[i].size;
171 lcd_printf (" %ld MB SDRAM, %ld MB NAND",
174 #ifdef CONFIG_MTD_NOR_FLASH
175 lcd_printf (",\n %ld MB NOR",
180 #endif /* CONFIG_LCD_INFO */
183 #ifdef CONFIG_DEBUG_UART_BOARD_INIT
184 void board_debug_uart_init(void)
186 at91_seriald_hw_init();
190 #ifdef CONFIG_BOARD_EARLY_INIT_F
191 int board_early_init_f(void)
193 #ifdef CONFIG_DEBUG_UART
202 /* arch number of AT91SAM9263EK-Board */
203 gd->bd->bi_arch_number = MACH_TYPE_AT91SAM9263EK;
204 /* adress of boot parameters */
205 gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
207 #ifdef CONFIG_CMD_NAND
208 at91sam9263ek_nand_hw_init();
210 #ifdef CONFIG_USB_OHCI_NEW
214 at91sam9263ek_lcd_hw_init();
221 gd->ram_size = get_ram_size((void *)CONFIG_SYS_SDRAM_BASE,
222 CONFIG_SYS_SDRAM_SIZE);
227 #ifdef CONFIG_RESET_PHY_R