arch/arm/mach-stm32mp/Kconfig

   1 if ARCH_STM32MP
   2
   3 config SPL
   4         select SPL_BOARD_INIT
   5         select SPL_CLK
   6         select SPL_DM
   7         select SPL_DM_SEQ_ALIAS
   8         select SPL_DRIVERS_MISC_SUPPORT
   9         select SPL_FRAMEWORK
  10         select SPL_GPIO_SUPPORT
  11         select SPL_LIBCOMMON_SUPPORT
  12         select SPL_LIBGENERIC_SUPPORT
  13         select SPL_OF_CONTROL
  14         select SPL_OF_TRANSLATE
  15         select SPL_PINCTRL
  16         select SPL_REGMAP
  17         select SPL_DM_RESET
  18         select SPL_SERIAL_SUPPORT
  19         select SPL_SYSCON
  20         select SPL_DRIVERS_MISC_SUPPORT
  21         imply SPL_LIBDISK_SUPPORT
  22
  23 config SYS_SOC
  24         default "stm32mp"
  25
  26 config TARGET_STM32MP1
  27         bool "Support stm32mp1xx"
  28         select ARCH_SUPPORT_PSCI
  29         select CPU_V7A
  30         select CPU_V7_HAS_NONSEC
  31         select CPU_V7_HAS_VIRT
  32         select PINCTRL_STM32
  33         select STM32_RCC
  34         select STM32_RESET
  35         select SYS_ARCH_TIMER
  36         select SYSRESET_SYSCON
  37         help
  38                 target STMicroelectronics SOC STM32MP1 family
  39                 STMicroelectronics MPU with core ARMv7
  40
  41 config SYS_TEXT_BASE
  42         prompt "U-Boot base address"
  43         default 0xC0100000
  44         help
  45                 configure the U-Boot base address
  46                 when DDR driver is used:
  47                   DDR + 1MB (0xC0100000)
  48
  49 config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
  50         hex "Partition on MMC2 to use to load U-Boot from"
  51         depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
  52         default 1
  53         help
  54           Partition on the second MMC to load U-Boot from when the MMC is being
  55           used in raw mode
  56
  57 source "board/st/stm32mp1/Kconfig"
  58
  59 # currently activated for debug / should be deactivated for real product
  60 if DEBUG_UART
  61
  62 config DEBUG_UART_BOARD_INIT
  63         default y
  64
  65 # debug on UART4 by default
  66 config DEBUG_UART_BASE
  67         default 0x40010000
  68
  69 # clock source is HSI on reset
  70 config DEBUG_UART_CLOCK
  71         default 64000000
  72 endif
  73
  74 endif