arch/arm/mach-stm32mp/Kconfig

   1 if ARCH_STM32MP
   2
   3 config SPL
   4         select SPL_BOARD_INIT
   5         select SPL_CLK
   6         select SPL_DM
   7         select SPL_DM_SEQ_ALIAS
   8         select SPL_FRAMEWORK
   9         select SPL_GPIO_SUPPORT
  10         select SPL_LIBCOMMON_SUPPORT
  11         select SPL_LIBGENERIC_SUPPORT
  12         select SPL_OF_CONTROL
  13         select SPL_OF_TRANSLATE
  14         select SPL_PINCTRL
  15         select SPL_REGMAP
  16         select SPL_RESET_SUPPORT
  17         select SPL_SERIAL_SUPPORT
  18         select SPL_SYSCON
  19         select SPL_DRIVERS_MISC_SUPPORT
  20         imply SPL_LIBDISK_SUPPORT
  21
  22 config SYS_SOC
  23         default "stm32mp"
  24
  25 config TARGET_STM32MP1
  26         bool "Support stm32mp1xx"
  27         select CPU_V7
  28         select PINCTRL_STM32
  29         select STM32_RESET
  30         select SYS_ARCH_TIMER
  31         select SYSRESET_SYSCON
  32         help
  33                 target STMicroelectronics SOC STM32MP1 family
  34                 STMicroelectronics MPU with core ARMv7
  35
  36 config SYS_TEXT_BASE
  37         prompt "U-Boot base address"
  38         default 0xC0100000
  39         help
  40                 configure the U-Boot base address
  41                 when DDR driver is used:
  42                   DDR + 1MB (0xC0100000)
  43
  44 config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
  45         hex "Partition on MMC2 to use to load U-Boot from"
  46         depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
  47         default 1
  48         help
  49           Partition on the second MMC to load U-Boot from when the MMC is being
  50           used in raw mode
  51
  52 source "board/st/stm32mp1/Kconfig"
  53
  54 endif