3 * Marvell Semiconductor <www.marvell.com>
4 * Written-by: Lei Wen <leiwen@marvell.com>
6 * SPDX-License-Identifier: GPL-2.0+
10 * This file should be included in board config header file.
12 * It supports common definitions for Armada XP platforms
15 #ifndef _MVEBU_CONFIG_H
16 #define _MVEBU_CONFIG_H
18 #include <asm/arch/soc.h>
20 #define MV88F78X60 /* for the DDR training bin_hdr code */
22 #define CONFIG_SYS_CACHELINE_SIZE 32
25 * By default kwbimage.cfg from board specific folder is used
26 * If for some board, different configuration file need to be used,
27 * CONFIG_SYS_KWD_CONFIG should be defined in board specific header file
29 #ifndef CONFIG_SYS_KWD_CONFIG
30 #define CONFIG_SYS_KWD_CONFIG $(CONFIG_BOARDDIR)/kwbimage.cfg
31 #endif /* CONFIG_SYS_KWD_CONFIG */
33 /* Add target to build it automatically upon "make" */
35 #define CONFIG_BUILD_TARGET "u-boot-spl.kwb"
37 #define CONFIG_BUILD_TARGET "u-boot.kwb"
40 /* end of 16M scrubbed by training in bootrom */
41 #define CONFIG_SYS_INIT_SP_ADDR 0x00FF0000
42 #define CONFIG_NR_DRAM_BANKS_MAX 2
44 #define MV_UART_CONSOLE_BASE MVEBU_UART0_BASE
47 * SPI Flash configuration
50 #define CONFIG_HARD_SPI 1
51 #define CONFIG_KIRKWOOD_SPI 1
52 #ifndef CONFIG_ENV_SPI_BUS
53 # define CONFIG_ENV_SPI_BUS 0
55 #ifndef CONFIG_ENV_SPI_CS
56 # define CONFIG_ENV_SPI_CS 0
58 #ifndef CONFIG_ENV_SPI_MAX_HZ
59 # define CONFIG_ENV_SPI_MAX_HZ 50000000
64 * Ethernet Driver configuration
67 #define CONFIG_CMD_MII
68 #define CONFIG_MII /* expose smi ove miiphy interface */
69 #define CONFIG_MVNETA /* Enable Marvell Gbe Controller Driver */
71 #define CONFIG_ENV_OVERWRITE /* ethaddr can be reprogrammed */
72 #define CONFIG_PHY_GIGE /* GbE speed/duplex detect */
73 #endif /* CONFIG_CMD_NET */
79 #ifndef CONFIG_SYS_I2C_SOFT
80 #define CONFIG_I2C_MVTWSI
82 #define CONFIG_SYS_I2C_SLAVE 0x0
83 #define CONFIG_SYS_I2C_SPEED 100000
86 #endif /* __MVEBU_CONFIG_H */