1 // SPDX-License-Identifier: GPL-2.0+
3 * Switch to non-secure mode
5 * Copyright (c) 2018 Heinrich Schuchardt
7 * This module contains the ARMv8 specific code required to adjust the exception
8 * level before booting an operating system.
13 #include <asm/setjmp.h>
16 * entry_non_secure() - entry point when switching to non-secure mode
18 * When switching to non-secure mode switch_to_non_secure_mode() calls this
19 * function passing a jump buffer. We use this jump buffer to restore the
20 * original stack and register state.
22 * @non_secure_jmp: jump buffer for restoring stack and registers
24 static void entry_non_secure(struct jmp_buf_data *non_secure_jmp)
27 debug("Reached non-secure mode\n");
29 /* Restore stack and registers saved in switch_to_non_secure_mode() */
30 longjmp(non_secure_jmp, 1);
34 * switch_to_non_secure_mode() - switch to non-secure mode
36 * Exception level EL3 is meant to be used by the secure monitor only (ARM
37 * trusted firmware being one embodiment). The operating system shall be
38 * started at exception level EL2. So here we check the exception level
39 * and switch it if necessary.
41 void switch_to_non_secure_mode(void)
43 struct jmp_buf_data non_secure_jmp;
45 /* On AArch64 we need to make sure we call our payload in < EL3 */
46 if (current_el() == 3) {
47 if (setjmp(&non_secure_jmp))
49 dcache_disable(); /* flush cache before switch to EL2 */
51 /* Move into EL2 and keep running there */
52 armv8_switch_to_el2((uintptr_t)&non_secure_jmp, 0, 0, 0,
53 (uintptr_t)entry_non_secure, ES_TO_AARCH64);